Volkswagen Mark IV Forum banner

MK4 A/C fan question

578 Views 1 Reply 2 Participants Last post by  northpole
So both my a/c fans can only rotate at high speed. Low speed is dead on both fans.

However, I do have one spare fan in my basement. Motor is in perfect condition but the plastic fan itself is broken:


My question is: How do I separate the plastic fan from the motor so that I can swap the motors? I can only swap the blown low speed resistor if it need be but I would prefer swapping the motors.

Any ideas? How is the fan attached? Force fit?
See less See more
1 - 2 of 2 Posts
you'll find the fan's axle has a securing clip that should be taken off than you can remove it from the engine
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.