Volkswagen Mark IV Forum banner
1 - 20 of 26 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
Hi

Question for ya...If i was looking to sell the following spec'd car, how much could i expect in return?

Silver 3Dr Golf Mk4 AGU with 138,000 on the clock, engine rebuild took place before conversion 6,000 miles ago!
Big Turbo Upgrade - T3/T4
T3 Manifold
Front Mount Intercooler
Forge Intake
RAMAIR cold air induction
440cc Injectors
4BAR fuel regulator
Walbro 225 Fuel Pump
VR6 Clutch with G60 Flywheel
VR6 MAF
Tial BOV
Tial 38mm External Wastegate
Screamer Pipe (connected to downpipe)
3" exhaust from Turbo back (original R32 Exhaust)
Big Brake upgrade (Drilled & Grooved)
Lowered on Weitech Coilovers
19" BBS LM Reps in silver/gun metal greyish
Original R32 rear bumper and side skirts
Interior : Recaro's
Pillar mount Boost Gauge
Everything else is standard!

Any comments appreciated!
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #12 ·
I'll get some pictures as soon as! I know mods dont add to value, but these arent fibreglass mods.

Stuart_Tate - Sorry, the engine is an AGU (Big Bore head)
 

·
Registered
Joined
·
506 Posts
AGU = large port head...

What was done on rebuild ie forged pistons, rods, valves?

Was it bored out?

What turbo is it garrett?

What make manifold is it?

Genuine R32 exhausts don't fit fwd golfs!!!

Who did the tuning work and remap?

Has it got fsh?

Depends on quality of work, condition of car and history, but I would say 2-3k with whay you have listed above..
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #14 ·
Yes sorry i forgot to list forged internals.. just rods. Pistons are fine for this power.

Its a Garrett Turbo, ATP Manifold, And i was taught the hard way that the exhausts dont fit, but i did remove the spare wheel well and custom piping from Turbo back. So it did eventually fit. Part Service History from 72,000 onwards... Car is in immaculate condition, no dents or scratches. Wheels are un scratched.

Only reason i posted this on here was because a guy from work has offered me a straight p/x for his Cupra R 225. Standard. He's valued it at £3,600.00.
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #18 ·
problem i have is, i shall be running 270-280bhp max which is obvious less power than what i have now... and to do a BT conversion all over again would be difficult in the near future! [brick]
 
1 - 20 of 26 Posts
Top